0
Start here
Lay the collar flat, lights facing up. Run the strap across it from slot to slot, with the velcro side of the strap facing up. The next steps start with the left end.
How to wear ThyRed
Takes about a minute.
1
Thread one end
Lay the collar flat with the lights facing up. Push the strap end through the slot at one end of the collar.
2
Fold and fasten
Fold the end back over the strap and press the hook and loop pad down.
3
Place it on your neck
Rest the collar on the front of your neck with the lights facing your skin. Bring both ends around to the back.
4
Thread the other end
Pass the free end of the strap through the slot on the other side of the collar.
5
Open and adjust
Now peel open the hook and loop end you closed in step 2. Pull the strap until the collar sits close to your neck, snug but never tight, then press the end against the other part of the strap.
6
Press to close
Press the strap end flat onto the strap. That's it. Plug in the control pod and start your session.
Questions about the fit
What if it still feels too loose?
Fold a small cloth and tuck it between the strap at the back and your skin. It takes up the slack and holds the collar closer to your neck.
What if it feels too tight?
Peel open the end at the back, give the strap a little slack and press it closed again. You should be able to slide one finger under the strap.
My hair gets caught in the velcro. What helps?
Tie your hair up or hold it out of the way before you close the strap. If a few strands get caught, open the strap slowly and free them first.
The velcro doesn't hold as well as before. Why?
Lint and hair collect in the hook side over time. Pick them out with your fingers or a soft brush, then press the end down firmly along the whole pad.